What does IDC connector stand for?
insulation-displacement contact
“An insulation-displacement contact (IDC), also known as insulation-piercing contact (IPC), is an electrical connector designed to be connected to the conductor(s) of an insulated cable by a connection process which forces a selectively sharpened blade or blades through the insulation, bypassing the need to strip the …
What are flat wire connectors called?
ZIF connectors are used to secure delicate ribbon cables, such as FFC (flat flex cables) or FPC (flexible printed circuit) cables. As the name implies, no force is needed to plug in or remove the cable.
Are IDC connectors reliable?
IDCs have provided a cost-effective and reliable alternative to crimp-to-wire and hard-soldering wires to a PCB. The harsh-environment IDC contact design offers reliability over time, temperature, and vibration with a repeatable/consistent termination process while allowing for reparability if needed.
Can you use IDC connectors with stranded wire?
The contact can accept both solid and stranded wires, which allows IDCs to be used in a broad range of applications. They support temperature requirements ranging from –40 to 125 C. IDCs have also been tested to withstand up to 50 g of shock.
What are FFC connectors?
Flexible Flat Cable (FFC) connectors are ribbon like connectors, made of flexible plastic, polymers, films, or engineered rubber and have a metallic connector at the end, which is embedded in parallel to the base.
What are ribbon connectors called?
Techopedia Explains Ribbon Cable The distinct multi-cable arrangement in a ribbon cable allows an insulation displacement connector (IDC) to be easily attached on its ends.
What is the difference between soldering crimping and IDC terminations?
IDC connectors create a reliable gas-tight connection as the connector blade is cold-welded to the conductor. Crimping is a totally different wire termination method. This was used to replace soldering techniques. In this method, the connection is made using a crimping tool.
How do you crimp an IDC?
Push the top clip down as hard as you can with your fingers so that it starts to clamp the cable. Now insert the connector into the vice and tighten the vice to crimp the connector to the cable. If strain relief is being used, double the cable back and insert the strain relief clip.
How do I connect small ribbon cable?
Push the ribbon cable flush with the guide on the opposite side. Push the cable through the clip until the tip of the cable pops out on the other side. Keep sliding the cable through until it hits the small vertical lip. This is the guideline for the cable, and the end of the cable must rest flush against the lip.