How do storage heater controls work?
Basic storage heaters have two main controls, an input (controls how much heat the heater stores) and an output (controls how quickly the heat escapes). Automatic storage heaters have an inbuilt sensor to monitor air temperature. The heater should automatically adjust its charge to match your chosen settings.
How do you use a Dimplex heater timer?
The heater must be connected to the electricity supply for the timer to operate. Set the timer by rotating the dial clockwise until the correct time of day is indicated opposite the datum mark (located at centre front of the timer – see Fig. 5). Set the timer switch to position.
How do you unlock a Dimplex heater?
To lock the controls press and hold both the Back button and Enter for three seconds. Child Lock will appear at the bottom of the screen. To unlock the control repeat the action by pressing both the Back button and Enter for three seconds.
Should storage heaters be left on all the time?
The ‘output’ setting of your storage heater should be turned off at night; and also when you are out of the room or out of the house. The ‘boost’ setting can be used to throw out extra warmth. But it uses expensive daytime electricity, so use all the stored heat first by opening the output fully before using boost.
Should you turn storage heaters off during the day?
During the day you can adjust the output to suit your needs. Remember, the higher the setting during the day, the less heat is saved for the evening. You can save more heat for the evening by keeping the setting low during the day, such as 1 when the room is warm enough or you are going out.
How do I turn on my Dimplex eco heater?
To bring the heater into use plug it in. Neon indicating lights located at the controls area will glow when the appliance is plugged into the mains. thermostat set to ‘ ‘ and the heat selection switch set to the required heat output the appliance switches on automatically when the temperature falls below +5°C to +8°C.
How do you turn on a Dimplex fireplace?
Touch Panel and Remote Controls The manual controls for the Dimplex Electric Fireplace are located on the front panel. When not activated, the icons are not visible. Touch the control panel to the right side of the white line to activate the icons. The selected setting is displayed on the left side of the panel.
Why is my Dimplex heater flashing red?
The display is flashing or staying red -If the Q-Rad is obstructed by furniture, for example, then please move the obstruction and switch the Q-Rad off at the wall for 15 minutes before turning it back on. This should reset the Q-Rad and the fault should have cleared.