How do I reset my GHD eclipse?
GHD Mk6 Eclipse
- Unplug the irons from the wall.
- Wait ten seconds.
- Hold the on/off button down while you plug them back in and keep it held for a further five seconds.
- Release the on/off button.
- Then turn on as usual.
Why is my GHD eclipse beeping continuously?
Shiver Mode is a feature that GHD straighteners have built in in all models after the GHD 3.1b. (so GHD4. 0 to 4.2b, 5.0 ect). It is designed so that when the temperature is below about 11 degrees C the ghds will not power the heater plates up and the GHD,s will just make a constant beeping noise.
How do I fix shiver mode on GHD?
To get them out of Shiver Mode, switch off and unplug. Hold the plates in your hands for a few minutes to warm them up, then try again. During the colder months store your ghd’s wrapped in a towel.
Can you repair GHD eclipse?
The GHD Eclipse is not repairable. A replacement mains cable is available from our online shop if yours is damaged (here). But make sure the cable is cut or damaged and the damage is stopping power getting to the irons!
Why have my GHD straighteners stopped working?
No power to your ghds could also mean the thermal fuse has blown inside. This is designed to blow when ghds overheat. They can blow prematurely for no reason other than prolonged use. However it could have blown due to a component failure on the chipboard that requires a full chip board replacement.
Why does my GHD flash red?
It’s normal for the straightener to flash solid red as soon as you turn the switch on. It will then beep and start flashing as soon as it’s hot and this tells you it’s ready to be used.
Why is my GHD flashing and not heating up?
Not a problem with the irons exactly, but if the irons are too cold when they are switched on you will get a continuous beep and flashing light and the irons will not heat up. GHD call this a feature and say it is to protect against damage occuring.
Why are my ghds flashing red and beeping?
1) The irons are too cold Not a problem with the irons exactly, but if the irons are too cold when they are switched on you will get a continuous beep and flashing light and the irons will not heat up. GHD call this a feature and say it is to protect against damage occuring.
Why is the red light flashing on my GHD straighteners?
When you turn the Straighteners on they bleep, the red light will keep flashing until it gets to the right temperature, then bleep again.